The best leaves for leaf mould

It's best to mix leaves of a similar type together, so that they rot down at the same speed.

Read our advice on the different types of autumn leaves and how best to use them, below.

Leaves that are quick to break down

Leaves that are low in fibrous lignin and high in nitrogen and calcium will produce leaf mould within a year. Add directly to a mesh bin or bagged without chopping.

Leaves to use: ash, beech, birch, cherry, elm, hornbeam, lime, oak, poplar, willow

Leaves that are slow to break down

Trees with large, tough leaves that are high in lignin and low in nitrogen and calcium take 18-24 months to break down. Chop up with a mower or garden shredder.

Leaves to use: deciduous shrubs, hawthorn, maple, magnolia, sycamore, horse chestnut (Aesculus hippocastanum)

Conifers

A waxy resin coats the needles, so they take over a year to break down. Leave uncovered and mix every six to eight weeks. Moisten in dry weather, ideally using rainwater. Use to mulch or pot acid-loving plants.

Leaves to use: pines, conifers

Evergreen leaves

Evergreen leaves also have a waxy coating and can stick together, slowing decomposition. Shredded, they rot down best in the heat of a mixed-ingredient compost bin or heap.

Leaves to use: aucuba, bay, holly, laurel, photinia, rhododendron, skimmia

Making leaf mould

Leaf mould can be made by storing leaves in a mesh bin, made of chicken wire pinned to wooden posts. Leaves should be moist, but not soaking wet, and must not be packed too tightly. Find out how to make a leaf mould bin. For smaller quantities, make leaf mould in plastic sacks - put moist leaves into plastic bin bags, loosely tied at the top and punched with holes in the sides.